Analysis of Automation Processes of Printed Circuit Boards Manufacturing Equipment

Authors

  • Marko Klepach NUWM
  • Mykola Klepach, National University of Water and Environmental Engineering
  • Leonid Kozak National University of Water and Environmental Engineering

DOI:

https://doi.org/10.31713/MCIT.2019.36

Keywords:

automation; simulation model; PID controller; optimization; movement control

Abstract

In this article, the authors present a process of the printed circuit boards manufacturing equipment simulation model design. The model was used to create, optimize and test the movement control subsystem of the device.

Downloads

Published

2019-11-05

How to Cite

Klepach, M., Klepach, M., & Kozak, L. (2019). Analysis of Automation Processes of Printed Circuit Boards Manufacturing Equipment. Modeling, Control and Information Technologies: Proceedings of International Scientific and Practical Conference, (3), 110–111. https://doi.org/10.31713/MCIT.2019.36

Issue

2019: Modeling, control and information technologies: Proceedings of III International scientific and practical conference

Section

Problems of automated control, optimization and parameters identification